Publicidad
Idiomas disponibles
Idiomas disponibles
2. INSTALLATION
2.1 Installation
Make sure that installation is performed correctly,
adhering to all of the instructions in the specific
installation guide provided with the appliance.
Warning
Always connect the water before the
power.
The appliance must be connected to ground in
compliance with electrical system safety standards.
>
Position the appliance with the aid of a second
person.
>
Never use the open door tolever the appliance into
place when fitting.
>
Avoid exerting too much pressure on the door
when open.
>
The appliance must not be installed near heat
sources. If this is not possible, suitable insulation
must be used.
>The appliance must not be exposed to direct
sunlight.
>
Do not use the appliance outdoors.
>
Installation and servicing should be carried out
by qualified personnel in accordance with current
standards.
>
Have the electrical connection performed by
authorised technical personnel.
>
For avoiding dangers, if the power supply cable is
damaged, contact technical support immediately
and they will replace it, so as to prevent any risk.
>
Always use any necessary/ required personal
protective equipment (PPE) before performing any
work on the appliance (installation, maintenance,
positioning or movement).
>
Before performing any operation on the appliance,
switch off the power supply.
>
This appliance can be used up to a maximum
altitude of 4,000 metres above sea level.
>If installed near another refrigerator or freezer,
keep it at a minimum distance of 2 cm.
>Do not try to repair the appliance yourself or
without the assistance of a qualified technician.
>Do not install/use the appliance outdoors.
>CAUTION: while positioning the appliance, make
sure that the power supply cable is not caught or
damaged.
>To prevent instability of the appliance, install and
secure it correctly as indicated in the instructions
provided in this manual.
www.fhiaba.com · www.thevettagroup.com · Info Line 1-855-4-FHIABA (1-855-434-4222)
2.2 Connection to the electrical power
supply
The appliance operates at 115 V AC, 60 Hz and is
equipped with a power supply cord with a 3-prong
grounded plug, which must be connected to a
corresponding 3-prong (15 Amp) grounding-type
wall receptacle.
Important
Do not use extension cords and/or
multiple adapters for connection.
Warning
If
energy
is
alternative energy power source (solar,
geothermal, etc..) or if home automation
systems are installed, it is necessary
to install the Alternative Energy Kit to
integrate the unit into the power grid.
2.3 Refrigerant
The refrigerant isobutane (R600a) is contained
within the refrigerant circuit of the appliance, a
natural gas with a high level of environmental
compatibility, which is nevertheless flammable.
>
During transportation and installation of the
appliance, be certain that none of the components
of the refrigerant circuit become damaged.
>
If the refrigerant circuit should become damaged:
– avoid open flames and sources of ignition;
– thoroughly ventilate the room in which the
appliance is situated.
ISO 7010 W021
supplied
through
an
9
EN
Publicidad
