Ascaso BIG DREAM T Manual De Usuario página 16

9 – Programming dose of coffee and hot water
To program the amount of coffee (volumetric dose) or hot water (set by time, not
volume), with the machine ON and ready to make coffee (keys of the keypad
permanently lit), press the programming button XL for 5 or 6 seconds until it is lit
intermittently while the rest of the keys are illuminated in a fixed manner.
Then press the key of the selection you want to program, which is lit intermittently at the
same time that the other four keys are off. The erogation process begins.
Once the desired quantity has been obtained, press again the key belonging to the
selection you are programming. The dispensing process is stopped, and the key light
is OFF. Press XL button until all keys are ON except for this one, and then press it
twice until machines gets back to working mode. You can also wait for 30 seconds so
machine gets back to working mode automatically.
ATTENTION!
In machines of 2 and 3 groups, when programming the left group, they are
automatically programmed with the same volume parameters located to the
right of this. You can program different selections at once, without getting out
of programming mode. Just follow same steps with the different selections you
need to set.
ATTENTION!
To program hot water buttons follow the same process. Short hot water selection
must be set through group 1, while large hot water selection must be set through
group 2.
If you want to get coffee at will (continuous), press the XL key. When you get the
desired amount, press again to interrupt the delivery.
16
Hot water selection
Short
Hot water selection 1 espresso
Large
1 lungo 2 espressos 2 lungo continuous
(press again
to discontinue
the dose)