Casselin CFRPG430 Manual De Instrucciones página 48

ELECTRICAL CONNECTION
The oven is fitted with an electric cable (230v - single phase) located at the rear and without a plug (fig.6).
The technical data are indicated on the CE identification plate (FIG.1).
THE ELECTRICAL CONNECTION OF THE OVEN TO THE NETWORK
MUST BE PERFORMED MANDATORY AND EXCLUSIVELY BY A
QUALIFIED TECHNICIAN (ELECTRICIAN) WHO HAS THE TECHNICAL
AND PROFESSIONAL KNOWLEDGE REQUIRED BY THE LAWS IN
FORCE IN THE COUNTRY WHERE THE OVEN IS USED.
'INSTALLATION COMPLETE.
THE MANUFACTURER DISCLAIMS ALL RESPONSIBILITY FOR
DAMAGE TO PERSONS, ANIMALS OR PROPERTY CAUSED BY
INCORRECT CONNECTIONS TO THE ELECTRICAL AND GAS
NETWORKS.
The connection to the power line must be made by interposing an automatic circuit breaker of the correct
power in which the opening distance between the contacts is at least 3 mm. The ground wire must not be
cut.
The voltage of the supply current when the furnace is working must not deviate from the value of the voltage
nominal ±10%.
It is absolutely necessary to connect the device to the ground.
The electrical diagram of the oven can be found in chapter 11 (page 36).
WHEN THE ELECTRICAL CONNECTION IS COMPLETE, THE
AUTHORIZED TECHNICIAN (ELECTRICIAN) MUST PROVIDE A
DECLARATION ATTESTING THE CONTINUITY MEASUREMENT OF THE
EQUIPOTENTIAL PROTECTION CIRCUIT.
13
TUBE FOR GAS CONNECTION
CAVO COLLEGAMENTO
CABLE FOR ELECTRICAL CONNECTION
ELETTRICO
FIG.6
TUBO COLLEGAMENTO
GAS
POSTERI
BACK OF
OR PART
OVEN