Cooper Lighting Solutions Greengate RC3 Instrucciones De Instalación página 15

Greengate
† Final dimmer output level is determined by the following combination:
High end trim level
●
Daylighting contribution
●
Demand Response value
●
If enough natural light is entering the space and any of these three features have been implemented, the target light level
may be lower than shown. Raise commands from pushbuttons or sliders do not override or raise the lighting above the
target threshold implemented by these advanced energy saving methods.
Room Controller Networking
This section applies to the RC3-PL-N, RC3D-PL-N and RC3DE-PL-N Room Controller models.
Room Controller Network Node
Network Node
The diagram below calls out some of the various components of the network node.
Address DIP Switch
Network Wiring Notes
The Room Controller network is designed to communicate with other Room Controller and ControlKeeper network
panels using a lighting control RS-485 network for communications. This allows the panels to share information and to be
programmed from a central location using the Keeper Enterprise Software.
Please refer to Table 1 for information on recommended network cables.
9850-000362-06 page 15
October 2022
RS-485 Connection
Terminating Jumper
Communication
Status LEDs
Reset Button
Room Controller
www.cooperlighting.com