Bobike one junior Manual Del Usuario página 17

A. Main seat
A2. Seat cushion
A3. Seat clamp
A4. Release button
A5. Center of gravity
A6. Backrest
B1. Foot protection plate
B2. Retractable footrest
B3. Protective film for the fork
B4. Metal attachment plate Ø[16-21]mm
B5. Fastening block
• This child bicycle seat must not be mounted in
folding bicycles.
• This child bicycle seat must not be used on speed
pedelecs above 25 km/h / 15,5mph.
• This child bicycle seat must not be mounted to
bicycles fitted with rear shock absorbers.
• This child bicycle seat must not be mounted to
motorized vehicles such as mopeds, scooters.
• This child junior bicycle seat is only suitable for
carrying children with a maximum weight of 35 Kg,
a minimum height of 110 cm, and above 6 years of
age, that are able to secure and keep their balance
autonomosly on the seat during the ride.
• The total weight of the cyclist and the child
transported must not exceed the maximum
permitted load permitted for the bicycle. Information
on the maximum load can be found in the operating
instructions of the bicycle. You can also contact the
manufacturer for this question.
• This child bicycle seat can be used on E-bikes and
Speed Pedelecs up to 25 km/h / 15,5mph.
• The seat may only be mounted on a bicycle suitable
for the attachment of such additional loads. Please
consult your bicycle or lugagge carrier instructions
manual.
• The position of the child bicycle seat must be
adjusted so that the bicycle rider does not touch the
Specific Instructions for Mounting the Seat in the Bicycle
1. To assemble the seat and the footrest protection
you need a hex key no. 4 (E). You could find this hex
AN0732_ONE_JUNIOR.indd 17
Bobike One® Junior
rear bicycle seat for luggage carrier
EN.
Table of content of product
Specific Instructions For Mounting
COMMON FEATURES
B6. Bolts M6
B7. Zip ties
C. Safety belt for bicycle frame
C1. Safety belt buckle
C2. Safety belt retainer
D. Traceability information
E. Hex Key (No. 4 Allen key)
F. Safety belt for child
F1. Safety belt buckle
F2. Safety belt retainer
child bicycle seat with the feet when in motion.
• It's very important to adjust correctly the seat and
its component parts for optimum comfort and safety
of the child. It's also important that the seat does not
slope forward, so that the child does not tend to slide
out of it. It is also important that the backrest slope
backward slightly.
FOR LUGGAGE CARRIERS: SPECIFIC FEATURES
• This junior bicycle seat must be assembled on a
carrier with at least 38kg/ 83.78 Lbs of capacity. (35
KG + Weight of the seat).
• For safety reasons this seat shall only be fitted
to luggage carriers in accordance with EN ISO
11243:2016.
• This Junior bicycle seat must be assembled on
luggage carriers with a width between 120 and 175
mm, a tube diameter between 10-16 mm.
• The child bicycle seat must be assembled on
bicycles with wheels with diameters of 26", 27,5", 28"
and 29".
• Check if all parts of the bicycle function correctly
with the child bicycle seat mounted.
• Check the instructions of the bicycle, and If you
have any doubts on fitting the child bicycle seat to
your bicycle, please contact your bicycle supplier for
further information.
key below the cushion (A2) at the right side by lifting
the flexible cushion edge.
17
01/02/23 23:1