Publicidad
Idiomas disponibles
Idiomas disponibles
during transport), replace the ROPS to retain the best protec-
tion.
Following an accident, check the ROPS, the operator's seat,
the seat belt, seat belt mountings and seat platform for pos-
sible damage. Before operating the machine, replace all dam-
aged parts.
IMPORTANT: Do not attempt to weld or straighten the
ROPS.
The ROPS structure's protective capability may be
impaired by structural damage, overturn or alter-
ation. Do not remove or alter any of the ROPS
parts. Do not attempt to weld or straighten ROPS.
Failure to adhere to these instructions could result
in severe injury or death.
If the ROPS is replaced, make sure to use the
proper hardware and apply the recommended
torque values to the attaching bolts.
ROPS Inspection
Inspect the ROPS after the first 20 hours of operation. Fol-
lowing the initial inspection, check the ROPS after every 500
hours of operation or every six months, whichever comes
first.
1. Check the torque of the ROPS mounting bolts. Tighten
the bolts to the correct torques as shown below if nec-
essary. Figure 3-8
2. Inspect the operator's seat and the mounting parts for
the seat belt. Tighten the bolts to the correct torque as
shown below if necessary and replace parts that show
wear or damage.
3. Check the seat platform to make sure it is secured
properly. Adjust or repair it as necessary.
Never operate the mower with the seat platform
improperly secured. The seat platform must be
properly secured to prevent the seat from moving/
tilting in the event of the mower tipping or rollover.
Never operate the mower with the seat latch un-
installed and/or improperly secured. The seat plat-
form must be securely latched to prevent the seat
from moving/tilting in the event of the mower tip-
ping or rollover.
Torque values:
ROPS mounting bolts . . . . . . . . . . . . . 99
Seat belt mounting hardware . . . . . . 65
608622CE
Mower Operation
The following provides you with detailed information on how
to operate the mower efficiently.
Driving the Mower
levers and steer as follows:
equal distance. Figure 3-9
an equal distance. Figure 3-9
N•m
forward from neutral than the left steering control lever.
forward from neutral than the right steering control lever.
Figure 3-9
3-5
B
A. ROPS mounting bolts
Figure 3-8
This mower features the SmoothTrak™ steering system.
Never make sudden stops or reverse direction,
especially when maneuvering on a slope. The
steering is designed for sensitive response. Rapid
movement of the control levers in either direction
could result in a reaction of the mower that can
cause serious injury.
After starting the engine, engage the steering control
To go forward, push the steering control levers forward an
To go in reverse, pull the steering control levers rearward
To turn left, move the right steering control lever farther
To turn right, move the left steering control lever farther
A
B. ROPS post
REV A
CZ
DA
DE
EN
ES
FR
IT
NL
PT
SV
Publicidad
