Publicidad
Idiomas disponibles
Idiomas disponibles
When mounting blades, rotate them after installation to
make sure blade tips do not touch each other or sides of the
mower.
CZ
Mower Blade Options
The following is a list of the approved mower blade options
that are available from Hustler
mower.
DA
Use only genuine Hustler
ensure that original standards are maintained.
Failure to use approved blades could lead to blade
breakage which could result in death, injury or
property damage.
DE
48" Side Discharge Deck
795757
601014
EN
601123
796623
796631
54" Side Discharge Deck
797696
ES
601012
601124
797704
797712
606990
FR
48" Rear Discharge Deck
601123
601014
795757
796623
IT
796631
796649
54" Rear Discharge Deck
601124
606251
NL
797712
797704
Seat Adjustment
The seat can be adjusted two different ways to obtain the
PT
most comfortable position:
1. Use the seat release lever to slide the seat forward and
rearward. Figure 4-5
2. Adjust the seat firmness by turning the ride adjust-
ment knob. Figure 4-5
SV
REV A
Turf Equipment for this
®
replacement blades to
®
BLADE, F16.50"-H-F-CW
BLADE, F16.50"-L-F-CW
BLADE, 16.50"-L-F-CW
BLADE, 16.50"-MUL-F-CW
BLADE, 16.50"-GAT-F-CW
BLADE, F18.50"-H-F-CW
BLADE F18.50"-L-F-CW
BLADE, 18.50"-L-F-CW
BLADE, 18.50"-MUL-F-CW
BLADE, 18.50"-GAT-F-CW
BLADE, L18.50"-H-F-CW
BLADE, 16.50"-L-F-CW
BLADE, F16.50"-L-F-CW
BLADE, F16.50"-H-F-CW
BLADE, 16.50"-MUL-F-CW
BLADE, 16.50"-GAT-F-CW
BLADE, 16.50"-CAT-F-CW
BLADE, 18.50"-L-F-CW
BLADE, 18.50"-H-F-CW
BLADE, 18.50"-GAT-F-CW
BLADE, 18.50"-MUL-F-CW
A. Seat release lever
Steering Control Lever Adjustment
The steering control levers can be adjusted for operator
comfort.
A.
To pivot the upper control levers forward or rearward,
loosen the cap screws that attach the upper control
lever to the lower lever. Then, pivot the upper control
lever. Tighten the cap screws. Figure 4-6
B.
To lower and raise the control levers, remove the cap
screws. Slide the upper control lever up or down and
align the holes in it with the holes in the lower lever.
Re-install the cap screws and tighten.
The steering control levers should be adjusted so that they
align with each other when in the neutral position.
A
B
C
A. Upper control lever
B. Cap screws
4-8
B
A
B. Ride adjustment knob
Figure 4-5
C. Lower control lever
Figure 4-6
608622CE
Publicidad
