Free2Move eSolutions easyWallbox Manual De Instalación página 517

4.11. Configuration via easyWallbox PowerUp (service app)
The final configuration for installation in Power Upgrade mode should be done
via the purpose-built,
easyWallbox
mode as required if not correctly configured via the app in compliance with the
following indications.
Safety limit:
configurable by the qualified personnel. This limit must comply with current local
regulations and be consistent with the maximum current allowed by the power
supply wiring and must be the lesser value of:
the current permitted by the power supply unit installed, including the

wiring sections,
the current permitted by current local regulations.

User limit:
configurable by the customer to set the maximum current/charge power.
DPM limit:
configurable by the customer. Optional only if the DPM function is used
following the installation of the current sensor supplied.
The maximum charge current/power of the vehicle will always be
less than the most stringent limit.
easyWallbox
will not recharge electric vehicles connected in Power Upgrade
maximum charge current/power value of easyWallbox, only
maximum charge current/power value of easyWallbox, also
current/power value of the electricity supply contract, also
PowerUp app.
43