Luano Camp AGRL9F3 Manual De Uso Y Mantenimiento página 108

WATER SYSTEM TROUBLESHOOTING
PROBLEM CAUSE
The pump does Battery is flat
not start when
the tap is opened
Contacts oxidized
Blown fuse
Cable disconnected
The pump starts The shut-off valve has a leak
when the taps
There is a leak in the water system
are closed
Damaged pump
The pump does The pressure switch is faulty
not stop when
the taps are
There is a leak in the water system
closed
There is air in the system
Water does not There is air in the pipes
flow from the
The tap is blocked
taps
The water pipe is bent
The filter is blocked
Frozen pipe
SOLUTION
Check the battery charge and:
- If available, connect to the 230V main
- Start the engine and make a run to allow the battery to recharge
Thoroughly clean the pump contacts
Check to see that the fuse panel is on and, if necessary, replace the
damaged fuse
Verify that the pump power cable is correct
Contact a repair shop authorised by LUANO CAMP for a replacement
Check the piping and contact a repair shop authorised by LUANO CAMP if
a leak is found
Contact a repair shop authorised by LUANO CAMP for a replacement
Contact a repair shop authorised by LUANO CAMP for a check and possi-
ble replacement
Check the piping and contact a repair shop authorised by LUANO CAMP if
a leak is found
Open all the taps to accelerate charging the system
Open all the taps to accelerate charging the system
Confirm by opening another tap and contact a repair shop authorised by
LUANO CAMP if necessary
Place the pipe in the correct position. In any event, contact a repair shop
authorised by LUANO CAMP for a replacement
Clean the filter following the instructions provided in the User and
Maintenance manual of the pump manufacturer
Warm up the pipe to allow for defrosting
108