Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction for buttons on remote controller
SAVE function:
Under cool mode, press SAVE button and the unit will operate under SAVE mode.
Dual-8nixie tube on remote controller displays "SE". Air conditioner will operate at
auto speed. Set temperature can't be adjusted. Press SAVE button again to exit
SAVE mode. Air conditioner turn back to original set speed and set temperature.
● This function is applicable to partial of models.
8
X-FAN button
After pressing this button under cooling or dry mode, remote controller displays the
character of "X-FAN" and X-FAN function is started up. Press this button again to
cancel X-FAN function. The character of "X-FAN" will disappear.
Note:
● After starting up X-FAN function, when turning off the unit, indoor fan will continue
to operate for a while at low speed to dry the residual water inside the indoor unit.
● When the unit operates under X-FAN mode, press "X-FAN" button can turn off
X-FAN function. Indoor fan stops operation immediately.
9
TEMP button
Press this button can see indoor set temperature, indoor ambient temperature or
outdoor ambient temperature on indoor unit's display. Temperature is set circularly
by remote controller as below:
● When selecting "
indoor unit displays set temperature.
● When selecting "
displays indoor ambient temperature.
● When selecting "
displays outdoor ambient temperature.
Note:
● Outdoor ambient temperature display may can't be selected for some models.
When indoor unit receives "
● Only for the model whose indoor unit has dual-8 display.
10
TIMER button
● At ON status, press this button once can set TIMER OFF. The character of HOUR
ON. After each pressing of "+" or "-" button, time will increase or decrease half an
no display
" by remote controller or no display, temperature indicator on
" by remote controller, temperature indicator on indoor unit
" by remote controller, temperature indicator on indoor unit
" signal, it displays indoor set temperature.
TIMER
Publicidad
