Transport And Installation Of The Welding Machine; Description Of The Items Of Equipment - Solter aeroprocess 2000 Manual De Instrucciones

TRANSPORT AND INSTALLATION OF THE WELDING MACHINE

The transport position must be as indicated on the packaging. Impacts should be avoided during transport of the ma-
chine. The machine must be located in a dry and well-ventilated area, away from water outlets and from the welding
station (to prevent metal dust entering the welding machine). The machine must be installed on a horizontal surface
with a maximum gradient of 10°. The machine must be connected to an electrical box, which should consist of a cir-
cuit breaker and an automatic switch. The circuit breaker protects people from direct or indirect contacts with electri-
cal parts. The automatic switch must be chosen according to the equipment nameplate. A switch with an
intensity/time ratio of the slow type (D curve) is recommended to prevent false triggering.
HANDLING AND ASSEMBLY OF THE MACHINE
To handle and move the Aeroprocess 2000 equipments, always use the front and rear handles.
To handle and move the Aeroprocess 3200 and 3220 equipments, firstly you have to assemble the front and the rear
wheels (using their respective screws). To move them vertically, use the eyebolts that have to be screwed to the base
of the unit. To move them horizontally, you must use the front handle.
EN

DESCRIPTION OF THE ITEMS OF EQUIPMENT

AEROPROCESS 2000
AEROPROCESS 3200 and AEROPROCESS 3220
SOLTER
SOLDADURA S.L. AEROPROCESS 5