Solter aeroprocess 2000 Manual De Instrucciones página 30

3- Make all connections between the equipment and the winder. You must select the polarity depending on the type
of wire that you will use. However, gas tube and control cable always have to be connected in the same place (1-2).
The order of connection is always the same, the power cord first, second, the gas connector and finally, the control
cable.
4 - Connect the ground cable to the desired position.
5 – Connect the MIG torch in its position.
6 – Connect the gas tube at the rear part of the power unit.
Do not connect the gas cylinder directly to the wire feeder, as it has no solenoid. The solenoid and the
shielding gas pressure sensor are located in the power unit in order to save gas consumption.
Ensure that all connectors are securely connected and that they may not present problems of false
SOLTER
SOLDADURA S.L.
Positive connection
This type of connection is the most common for different types of wire. The power
cable is connected to the positive pole and the earth clamp to the negative pole.
Negative connection
This type of connection is less frequent. It is used for tubular steel wires without
gas or with gases of basic type. The power cable is connected to the negative pole
and the earth clamp to the positive pole.
You are recommended to see the polarity specifications given by the wire manufac-
turer, as these may vary.
The standard AEROFEED winder comes with a 1.7m cable (73368). If desired, the
same cable is available with lengths of 5m (73369) and 10m (73370).
ATTENTION
ATTENTION
contacts.
AEROPROCESS 8