Connection Of The Earth Clamp; Connection Of The Torch; Gas Connection - Solter aeroprocess 2000 Manual De Instrucciones

1 - Control panel
2 - Negative pole connector
3 - Euroconnector
4 - Gas connector
5 - Aerofeed connector
6 - Positive pole connector
7 - Gas input
8 - 2A Fuse (control)
9 - Main switch
10 - Mains connection

CONNECTION OF THE EARTH CLAMP

The earth clamp must be connected as close as possible to the workpiece and the other side of the cable must be
connected to the machine (in the desired position according with the polarity). The contact surface with the workpiece
should be as large as possible. Make sure that the surface is completely clean and free of paint and rust.
The following table shows the cable section, recommended by Solter Soldadura, according to amperage and opera-
ting cycle for lengths of less than 25m. These data are for reference and may NOT suit all applications. If the cable
overheats, use a larger cable section.
Section (mm 2 ) for X<60%
Section (mm ) for X>60%
2

CONNECTION OF THE TORCH

Connect the MIG torch in its position taking special care to ensure it is tightly screwed. Make sure that the torch is
going to be used is suitable for the current levels and operating cycle that the application requires. You can use an
air-cooled or water-cooled torch. Solter has different torches to suit the needs of each customer. See table below.
SX-36 4m
SX-36 3m ALU
SX-501 4m
SX-501 3m ALU

GAS CONNECTION

SOLTER
SOLDADURA S.L.
100 150
16 25
16 25
TORCH REFRIGERATIÓN
Liquid
Liquid
Welding current (A)
200 250
25 35
35 50
DUTY CICLE
Air 270A 60%
Air 270A 60%
500A 60%
500A 60%
AEROPROCESS
300 350 400
50 50
70 70
REF.
56033
56077
56075
56078
70
90
6