8.2.1 Running function as configured MyMode
For running over longer periods of time, the prosthetist can configure a "Run
ning" MyMode which can be activated using the cockpit app, a movement pat
tern or the remote control (special accessory).
In this mode, every step will be performed as a running step with larger swing
phase angle and no preflexion at heel strike (PreFlex) (see Page 81).
INFORMATION
The running function will work with specialised running feet such as the 1E90 Sprinter and 1E95
Challenger as well as with prosthetic feet with axial compression such as the 1C61 Triton Vertic
al Shock. For details on assembly and alignment please refer to the instructions for use of the
foot.
Feet without axial compression are generally not suited for running.
8.2.2 Switching MyModes with the cockpit app
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by
connecting/disconnecting the Bluetooth battery charger. Bluetooth is then turned on for approx.
2 minutes. During this time, the app must be started and used to establish a connection. If
required, Bluetooth on the prosthesis can be switched on permanently afterwards (see
Page 78).
INFORMATION
When mute mode (silent mode) is activated, no beep and vibration signals are generated.
Once a connection to a prosthesis has been established, the cockpit app can be used to switch
between the MyModes.
Product
1. Basic Mode
2. Golf
1
2
3
100%
1. Basic Mode
1) Tap the symbol of the MyMode (1) you want in the main
menu of the app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the act
ive mode.
→ The current mode is also indicated by the name on the
lower edge of the screen (3).
Ottobock | 73