Publicidad
support@nextlevelracing.com
1 x SHIFTER PLATE
1 x HANDBRAKE PLATE
4 x VELCRO CABLE TIES
2 x PACKAGING STRAPS
Rear Leg Bolts
1 x M6 NYLOCK NUT
1 x M5 30mm PHILLIPS HEAD
1 x M6 ALLEN KEY / PHILLIPS HEAD
1 x M5 ALLEN KEY
NOTE: Some items come with
rust resistant coating
4 x REMOVABLE BUCKLES
2 x STRENGTHENING STRAPS
(pre-installed)
Electronic's Hardware
Electronic's Hardware
12 x M6 WASHERS
12 x M6 16mm SOCKET HEAD
Pedal Brackets Bolts
Backrest Latch Bolts
1 x M5 25mm COUNTERSUNK HEAD
1 x M6 36mm PHILLIPS HEAD
1 x M5 / M6 WRENCH
6
1
USING NLR LITE SERIES HUBS
TIGHT
LOOSE
Open and close the cam lever to unlock and lock the hubs respectively. Make sure the cam is tightly
closed by spinning the lever clockwise before sitting in the cockpit to avoid failure.
2
ASSEMBLY PROCESS
Insert the Backrest Bottom Tubes through the openings in the back of the Backrest. Press the spring-loaded pin
to lock the tubes in place. Top holes will create a taller backrest and bottom holes will create a shorter one.
Video Instruction: bit.ly/nlrbuild
Do not adjust the hubs while user is
sitting in cockpit, Make sure user is out
of the cockpit before adjusting.
Make sure the hubs are tightened fully
before using the cockpit. (Spin the hub
clockwise to ensure it is fully tight)
Repeat
on Other
Side
User Height
7
Publicidad
