Publicidad
support@nextlevelracing.com
3
A
B
Repeat
on Other
Side
A) Uninstall the bolts and nuts from the Backrest Bottom Tube reclining hinges. B) Align the mounting holes on the Backrest
Bottom Tubes hinges with the Main Frame mounting holes. Bolt through and secure using the bolts and nuts uninstalled in Step 3A.
4
A
B
Repeat
on Other
Side
A) Open the cam lever on the Hubs to allow them to move freely. B) Unfold the Front Leg. C) Lock the cam lever
to lock the Front Leg in place.
Repeat
on Other
C
Side
Make sure the hubs are tightened fully
before using the cockpit. (Spin the hub
clockwise to ensure it is fully tight)
8
5
A
B
Repeat
on Other
Side
A) Pull out the reclining knobs. B) Unfold the Backrest. C) Release the reclining knob to lock the Backrest in
place. Ensure the pin is properly secured through the reclining hinge side plate to prevent failure.
6
A
Repeat
on Other
Side
NOTE: Pull the connection points on
the main frame apart to the same width
as the back leg for easy installation.
A) Remove the pre-installed bolts and nuts from the Main Frame. B) Align the tube ends of the Back Leg with the
tube openings of the Main Frame. Bolt through and secure using the bolts and nuts previously uninstalled.
Video Instruction: bit.ly/nlrbuild
C
Repeat
on Other
Side
B
9
Publicidad
