SIS SIS10.ESY.00 Manual Del Usuario página 43

1.29. How to install the advanced display
Figure 22: Advanced display of the SIS Easy anti-collision
device
4.4.1 Cab installation
Points to bear in mind when installing the advanced display in the cab.
•
The display must be located in a clearly visible position.
•
The display must be located in the most impact-free position possible.
•
The display must be located so that the programming button is easily accessible.
•
The cable must be laid and secured in such a way as to protect it from damage by impact or wrenching.
•
The display is IP41 protected, which means it must NOT be exposed to wet weather conditions or washed.
2
3
Figure 12: Example of positioning the display in the driver's cab
The display (Figure 11) is considered the heart of the system in terms of
installation. All the input and output signals travel along the pre-mounted cable.
The connectors are not pre-mounted to make it easier to pass the cable along
ducts or sheaths present on the vehicle.
Once powered on, it supplies all the other devices connected to it.
1
Pagina 43
Figura 12 shows three possible points of installation of the
advanced display inside the cab.
When the display is mounted on an upright (2), make sure it does
not interfere with the operator getting into or out of the cab.
MNL.000001 Rev.03 25.09.2019