SIS SIS10.ESY.00 Manual Del Usuario página 47

1.33. Switching the SIS EASY system on and off
When the device has been installed and the desired parameters entered, and at the start of each shift, the Buyer/User must start up the
vehicle and then proceed as follows.
•
Check that the SIS Easy anti-collision device activates when the vehicle is switched on, namely that:
o
the display (ref. 3, Figura 16) lights up green;
o
the light (ref. 4, Figura 17) flashes blue; otherwise contact your local dealer because the sensor may be malfunctioning;
o
the light (ref. 5, Figura 17) signals obstacles correctly, i.e. it displays the correct colour based on the distance of the
obstacle.
•
Operate the vehicle at reduced speed in reverse to check operation of the anti-collision device: the display must show one of
the colours indicated under point 5.3 - SIS Easy anti-collision device operating modes. Do not use people or structural
elements in the workplace as obstacles.
•
Contact the Fitter immediately if the device does not signal the obstacle correctly.
2
1
Figure 16: Anti-collision device display
1.34. SIS EASY Easy operating modes
Hereunder a description of the possible statuses of the SIS EASY Easy system.
No obstacle in the setted range
Obstacle in the detection range
(*) : SIS Easy System provides automatic diagnosis functions. RED+BLUE indication can be due to :
•
Sensor electrical disconnection
•
Receiving/Trasnmitting failure
In the first case please verify the connection of the sensor cable both on sensor and display side. Verify as well that the cable is not damaged. In case
no problems are detected please contact the fitter/dealer.
Situazione
Risk of imminent collision
System failure(*)
1
5
2
3
3
Figure 26: Anti-collision device sensor
Pagina 47
MNL.000001
Tipologia di allarme
GREEN light
NO audible alerts
Yellow light
Low frequency audible alert
RED light
Higher frequency audible alert
RED and BLUE light
NO audible alerts
Rev.03 25.09.2019
4