Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
- Adjust the adjustable rest (C, fig. 7) so that the machine is resting firmly on the
ground and then tighten the lock-nut on the adjuster bolt.
- Unscrew the nuts that lock the two screws (A, fig. 8) in the holes of the guard pin and
remove the screws.
- Fit the guard tube (B, fig. 8) into the support pin, lining up the two sets of holes.
- Fit the two screws into the holes and lock the tube to the support by tightening the
relative nuts.
- Position the wheel guard (C, fig. 8) on the tube and fix it using the specific hose clamps,
using the holes in the guard.
- Remove the safety screw (A, fig. 9) which prevents the lift carriage from moving during
transport.
- Fit the lift handle into the wheel support plate and fix it in position using the 6 screws
provided (B, fig. 9).
- Clamp the control pipelines to the plate as shown in figure 9a.
- Connect the pipeline marked with the coloured band to the snap connection inside
the lift column (C, fig. 9A).
- Connect the other pipeline to the joint inside the column (D, fig. 9A).
- Connect the machine's pneumatic system to the workshop distribution system. For
the connection procedures, refer to the "COMPRESSED AIR HOOK-UP" section.
- Check that the lift is working correctly. Pay special attention to the section of
sheathing leading from the support plate to the lift column; it must never be taut
during vertical movement of the plate.
Main operating parts of the machine (fig. 4)
A) Automatic diameter and distance measuring arm
B) Display panel
E) Cone holder
G) Weight-holder lid
H) Wheel shaft
I) Master switch
J) Air filter regulator unit
K) Handling holes
L) Wheel guard
M) Lift control
A) wheel inside (left hand) display
B) wheel outside (right hand) display
C) wheel inside position indicator
D) wheel outside position indicator
E) START key
F) STOP key
54
Fitting the guard (fig. 8)
Fitting the lift (fig.9-9A)
Display panel (fig.6)
MT 2450 operator's manual
Publicidad
Capítulos
Tabla de contenido
