Mondolfo Ferro MT 2450 Manual De Uso página 87

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

The distance values measured with the automatic sensor are not
the same as the values read on the millimetre rule.
The sensor has not been positioned correctly during measuring.
➥ Bring the sensor to the position shown in fig. 14 and follow the instructions in the
ENTERING THE WHEEL DATA section.
The sensor is not calibrated.
➥ Carry out the sensor calibration procedure.
The automatic sensor does not work.
The sensor was not in the rest position at switch-on (Err 10 or Err 11) and the
ENTER button was pressed to enter the geometric data with the keypad, disabling
control of the automatic sensor.
➥ Switch the machine off, return the sensor to the correct position and switch it back
on.
The sensor is not calibrated.
➥ Carry out the sensor calibration procedure.
The FU2 and/or FU3 fuses on the power supply circuit board have blown.
➥ Replace the blown fuse.
When START is pressed the wheel remains stationary (the
The guard is raised (the message "Cr Err" appears).
➥ Lower the guard.
The FU1 and/or FU5 fuses on the power supply circuit board have blown.
➥ Replace the blown fuse.
The machine displays unsteady imbalance values.
The machine has been jolted during the spin.
➥ Repeat the spin, taking care not to disturb the machine while measuring is in
progress.
The machine is not soundly installed on the flooring.
➥ Check the installation and adjust the support feet, using shims if necessary.
The wheel is not properly clamped.
➥ Tighten the clamping ring-nut firmly.
Several spins are required in order to balance a wheel.
The machine has been jolted during the spin.
➥ Repeat the spin, taking care not to disturb the machine while measuring is in
progress.
The machine is not soundly installed on the flooring.
➥ Check the installation and adjust the support feet, using shims if necessary.
The wheel is not properly clamped.
➥ Tighten the clamping ring-nut firmly.
The machine is not correctly calibrated.
➥ Carry out the sensitivity calibration procedure.
MT 2450 operator's manual
machine does not start)
GB
87

Publicidad

Tabla de contenido
loading

Productos relacionados para Mondolfo Ferro MT 2450

Tabla de contenido