Special Cases - Mondolfo Ferro MT 2450 Manual De Uso

key is pressed now, the system temporarily exits from the OPT program
If the
(to return, repeat the initial OPT program activation procedure).
- Remove the wheel from the balancing machine.
Rotate the tyre (switching around if necessary) on the rim, until the mark made
previously corresponds with the valve (rotation through 180°).
- Re-fit the complete wheel on the balancing machine.
- Rotate the wheel until the valve (or hole) is at 12 o'clock.
- Press the
- Carry out a wheel spin.
With the completion of the fourth spin, the optimization program has been completed
and the weights to be added to balance the wheel will be displayed on the monitor.
If an error has been made that may negatively affect the end result, the machine will
indicate this error with the "OPT ERR" message. This means that the entire procedure
should be repeated from the beginning.
- If execution of the first spin with rim only is not required, the first phase can be
skipped by pressing the
program. The wheel complete with tyre is then placed on the balancing machine,
and the phases which follow (2, 3 and 4) are carried out as described previously.
- On completion of the second and third wheel spins, the messages "OUT 1"and
"OUT 2" appear on the display respectively. In this case, users are advised to exit
from the program by pressing the
to balance the wheel will appear on the display. By following this procedure, the
user breaks off execution of the program, at the cost of a small reduction in the final
results. However, the
optimisation procedure.
- On completion of the third wheel spin, the instruction to reverse the direction in
which the tyre is fitted on the rim may appear. If the user does not wish to reverse
the direction or this is not possible, the
will give the instructions for completion of the program without reversal.
- If a different working environment is recalled between one phase of the OPT program
and the next, execution restarts from the point where it had been interrupted when
the working environment in which the user was working with the OPT function is
recalled.
MT 2450 operator's manual
key.

Special cases

key immediately after selection of the OPT
key can be pressed to continue execution of the
key; the values of the weights necessary
key can be pressed; the machine
GB
77