Entering Wheel Data In Manual Mode - Mondolfo Ferro MT 2450 Manual De Uso

- On completion press
the new dimensions, or lower the wheel guard to perform a spin.
If the automatic measurement system fails to operate, the geometrical data can be
entered manually by proceeding as follows.
- Press the
- Measure the width of the rim using the caliper provided (fig. 15).
- Modify the width value displayed by pressing the
the desired number is set. The value can be set in millimetres or the values already
set can be converted from inches to millimetres by pressing the
- Values set previously can be increased or decreased quickly by keeping the
and keys pressed.
- Press the
entering of the diameter.
- Read the nominal rim diameter value on the tyre.
- Modify the diameter value displayed by pressing the
the number read is set. The diameter can be set in millimetres or the values already
set can be converted from inches to millimetres by pressing the
- Press the
entering of the distance.
- Bring the distance measuring arm into contact with the inside of the rim (fig. 14).
- Read the distance between the wheel and the cabinet on the rule provided.
- Modify the distance value displayed by pressing the
the number read is set.
66
to display the imbalance values recalculated to suit

Entering wheel data in manual mode

key.
key to confirm the previous data and preset the machine for
key to confirm the previous data and preset the machine for
and keys until
key.
and
key.
and keys until
MT 2450 operator's manual
keys until