Balancing Truck Or Car Wheels; Wheel Data Input - Mondolfo Ferro MT 2450 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

BALANCING TRUCK OR CAR WHEELS

The balancing machine is able to balance both truck and car wheels. Since there are
substantial differences between the two balancing modes, the operating function
appropriate for the type of wheel to be balanced has to be selected in advance.
The procedure for selecting the balancing function is as follows:
- Press the
required
- Press the
The machine envisages automatic input of the distance value and input of the width
and diameter by means of the keypad.
- Bring the automatic sensor arm (A, fig. 4) into contact with the inside of the rim as
shown in fig. 14.
Take the greatest care to position the arm correctly in order to obtain precise
reading of the data.
- Keep the arm in contact with the rim until the machine has acquired the wheel's diameter
and distance values. The geometric data are displayed in sequence:
d
distance value;
di
diameter value;
- Check the value measured and then return the arm to the rest position. The machine
now prepares for input of the width.
If an incorrect value has been acquired during the measurement operation, move the
arm to the rest position and then repeat the operation.
- Measure the width of the rim using the special caliper (fig. 15).
- Modify the width value display by pressing the
number required is obtained.
- Press the
key to confirm the value entered.
- The WIDTH can be obtained in millimetres, or values already obtained can be
converted from inches to millimetres by pressing the
The
values set previously.
MT 2450 operator's manual
keys until the light corresponding to the balancing function
key to confirm the selection.

WHEEL DATA INPUT

keys can be kept pressed for rapid increase or decrease of the
illuminates.
keys until the
key.
GB
65

Publicidad

Tabla de contenido
loading

Productos relacionados para Mondolfo Ferro MT 2450

Tabla de contenido