Publicidad
Raise the fan up to mounting bracket (a), and then insert one rubber bumper (b) between the mounting plate and
A
mounting bracket� Position the fan, and then secure it with the other mounting bracket (a) and the remaining mounting
hardware� Tighten all hardware�
Hardware:
c. 6 mm Nylock nut
Slide the wiring cover (d) into position, allowing about a 1/8" (3 mm) gap to the ceiling� Rotate the wiring cover so that
B
the mounting slots align with the screw holes� Secure the wiring cover screws (e) on both sides of the extension tube
to hold the cover in position� If there is not enough clearance between the wiring cover and ceiling, the screw can be
moved to the lower hole on the extension tube� Make sure that there are no wires visible�
Slide the wiring cover trim (f) up the extension tube, aligning the tabs on the inside of the ring with the slots on the bottom
of the wiring cover� Twist clockwise to snap the wiring cover trim into position as shown�
A2
19
HAIKU
®
BY BIG ASS FANS
WWW.BIGASSFANS.COM/TECHNICAL-SUPPORT
(877) BIG FANS
●
●
Publicidad
