Publicidad
Slide the wiring cover (a) into position, allowing about a 1/8" (3 mm) gap to the ceiling� Rotate the wiring cover so that the
mounting slots align with the screw holes� Secure the wiring cover screws (b) on both sides of the extension tube to hold the
cover in position� Make sure that there are no wires visible�
Slide the wiring cover trim (c) up the extension tube, aligning the tabs on the inside of the ring with the slots on the bottom of
the wiring cover� Twist clockwise to snap the wiring cover trim into position as shown� If there is not enough clearance between
the wiring cover and ceiling, the screw can be moved to the lower hole on the extension tube.
X2
27
HAIKU
®
BY BIG ASS FANS
WWW.BIGASSFANS.COM/TECHNICAL-SUPPORT
(877) BIG FANS
●
●
Publicidad
