Preparation; Removal Of Aligners - JF 1000 AT Manual De Instrucciones

16
Operation Technical Manual

PREPARATION

To fit the separately purchased JF 1000-AT in a
JF 92 Z4 / Z6 / Z10, JF C40, JF C60 or JF C-120
harvester, some adjustments will be required on
your harvester:
ƒ Remove the aligners, bender and fairing* from
the harvester.
ƒ Replace the crown shaft of the gathering platform
by the longer shaft that follows with the head.
ƒ Install the cover on the bottom of the head
gathering platform.
ƒ The instructions for the above adjustments are
described below.
*On models equipped with fairing.
NOTE!
The longer shaft, housing bottom cover and
fasteners are supplied along with the JF 1000-AT
Head.
The procedure is the same for JF harvesters with
belt drive or cardan shaft.
A

REMOVAL OF ALIGNERS

1.
Remove the bender (A).
2.
Remove the fairing (B)*.
3.
Remove the 2 aligners (C).
*On models equipped with fairing.
B
C
A
C