Assembly Of The Central Deflector And The Aligner Fingers - JF 1000 AT Manual De Instrucciones

CENTRAL DEFLECTOR
ALIGNER FINGERS
B
B
D
28
Operation Technical Manual
ASSEMBLY OF THE CENTRAL
DEFLECTOR AND THE ALIGNER FINGERS
The aligner fingers (right and left) and the central
deflector (figure on the side) goes disassembled
from the head. Their assembly is easy, just fix them
with bolts, washers and nuts supplied with the head.
NOTE!
The screws, nuts and washers are located in the
kit supplied with the head.
1.
Fix the two aligners with bolts (A) and nuts (B)
(figure on the side).
A
A = hex bolt M10 x 30 mm (04 un)
B = flat washer Ø10 mm (04 un)
B = lock washer Ø10 mm (04 un)
2.
Fix the central deflector with bolts (C), washers
(D) and nuts (E) (figure on the side).
C
B = lock washer Ø10 mm (02 un)
B = flat washer Ø10 mm (04 un)
C = hex bolt M10 x 75 mm (02 un)
D = hex nut M10 with nylon lock (02 un)