Assembly Of The Chain Tensioner - JF 1000 AT Manual De Instrucciones

TENSIONER
D
RULER
F
E
TENSIONER

ASSEMBLY OF THE CHAIN TENSIONER

1.
Fit the chain tensioner on the two pins of the
head, as shown in the picture besides. Use two
shims (D) in each pin.
SHIM (D)
16,5 mm
2.
After being fit, use a ruler and check the
alignment of the sprocket of the tensioner with
the other sprockets. If needed, add or remove
shims (D), until achieve alignment.
3.
After achieving alignment with the other
sprockets, put two bushes (E) and the elastic
rings (F), fixing the tensioner on the pins.
The picture besides shows the chain tensioner
assembled.
IMPORTANT!
The sprockets must work perfectly aligned,
otherwise, the chain will be damaged.
NOTE!
The spacers are in the kit supplied with the head.
JF 1000-AT
26 mm
1,9 mm
33