Assembly The Head In The Harvester - JF 1000 AT Manual De Instrucciones

L
M
N
ASSEMBLY THE HEAD IN THE
HARVESTER
1.
Assemble the head in the harvester, fitting it to
the two fasteners (L).
2.
Attach the platform to the machine with the 2
bolts and washers (M).
M = hex nut 7/16" with nylon lock (02 un)
M = flat washer Ø12 x Ø29 x 4.76 (02 un)
3.
Complete fastening with 2 bolts, washers and
nuts (N).
N = Hex bolt 7/16" x 2" (02 un)
N = flat washer Ø12 x Ø29 x 4.76 (02 un)
N = Hex nut 7/16" with nylon lock (02 un)
NOTE!
The figure on the side shows the head without
the two drums just to facilitate the location of the
screws. It is not necessary to disassemble the
drums to secure the head to the harvester.
JF 1000-AT
31