Publicidad
Idiomas disponibles
Idiomas disponibles
Since the appliance is used for preparing foods
for human consumption, special care must be
paid to everything relating to hygiene, and the
appliance and the entire surrounding environ-
ment must constantly be kept clean.
Important
Before starting any cleaning operation, always
turn off the gas supply tap, cut off the electric-
ity supply using the master switch and allow
the appliance to cool.
The precautions which follow are also important.
Caution - Warning
When using detergents, rubber gloves, pro-
tective mask and safety goggles must be
worn in accordance with the relevant safety
regulations.
– Clean all parts of the appliance with warm wa-
ter, food-approved detergents and non-abra-
sive materials only.
– Thoroughly clean all parts which come into di-
rect or indirect contact with foods and all sur-
rounding areas.
The appliance has been tested before being put
GB
into service. The information provided below
is intended to assist in the identifi cation and
correction of any anomalies and malfunctions
which might occur during use.
The user can solve some of these problems him-
self, but for others specifi c technical knowledge
or skill is required, and so they must only be car-
ried out by qualifi ed staff with recognised experi-
ence acquired in the specifi c sector of operation.
Faults
Smell of gas.
The pilot light goes out.
_ut_GB
CLEANING INSTRUCTIONS
– After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
Never use products containing substances
harmful or hazardous for health (solvents, pe-
troleum spirits, etc.).
– Rinse surfaces with drinking water and dry.
– Pressurised water jets may only be used on ex-
ternal parts.
– Take special care not to damage stainless steel
surfaces. In particular, avoid the use of corrosive
products and do not use abrasive materials or
sharp tools.
– Remove food residues immediately before they
set.
– Remove the limescale deposits which may form
on some of the appliance's surfaces.
FAULT
TROUBLESHOOTING
For all requirements contact the agents or
the headquarters of Angelo Po which can be
found in the contacts section of the website
http://www.angelopo.com.
Causes
Occasional leak because
fl ame has gone out.
The thermocouple has not
warmed up enough.
-
-
Caution - Warning
Important
Remedies
Turn off the gas supply tap and
ventilate the room.
Make more attempts to light the
fl ame.
ENGLISH
Publicidad
