MULTIPIEZO
04 Û INSTALLATION
04.1 Û FIRST INSTALLATION
The device must be installed in a comfortable
place suitable for its use.
EN
The multipiezo can be purchased ready for it
to be used instantly or may have to be enabled
by typing an activation key.
04.2 Û SAFETY PRECAUTIONS DURING INSTALLATION
WARNING: Contraindications.
Interference with other equipment.
Though compliant with the standard IEC
60601-1-2, the multipiezo may nonetheless
interfere with other devices nearby.
The multipiezo must not be used near to
or stacked on other devices. However, if
this were to prove necessary, you must
check and monitor correct operation of the
device in that configuration.
WARNING: Contraindications.
Interference from other equipment. An
electrical scalpel or other electro-surgical
units near the multipiezo device may
interfere with its correct operation.
CAUTION: The electrical system of the
premises in which the device is installed
and used must be compliant to the norms
in force and to the relative electrical safety
precautions.
CAUTION: To avoid any risk of electric
shock this device must be grounded.
WARNING: Do not install the device in
places where there is a risk of explosion.
04.3 Û CONNECTION OF THE ACCESSORIES
Connect the foot pedal to the back of
the device in the socket marked with the
symbol
by means of the plug of the
pedal cable, until you hear a "click" sound.
10
In the case that your device requires an
activation key, the procedures to follow may
vary from country to country.
Always refer to your retailer to obtain
information on the above.
The device cannot operate in environments
where anesthetic or flammable mixtures
are present.
WARNING: Install the device in a place
protected against collisions or against
accidental sprays of water or liquids.
WARNING: Do not install the device
above or near heat sources. Foresee
adequate air circulation around the device
when installing it.
CAUTION: Do not expose the device to
direct sunlight or to sources of UV light.
CAUTION: The device can be
transported, but it must be handled with
care when it is displaced. Position the foot
pedal on ground, so that it can only be
activated intentionally by the operator.
CAUTION: Before connecting the
handpiece to its cord, make sure that
the electrical contacts are perfectly dry,
on both sides. If need be, dry them with
compressed air.
1