Publicidad
Idiomas disponibles
Idiomas disponibles
HARDWARE COMPONENTS
Note: Tools required: medium phillips screw driver,
5/16" open end or adjustable wrench.
UNPACKING
1. Remove the heater from the carton.
2. Remove all packing materials applied to the
heater for shipment.
3. Remove all items from the carton.
4. Check the heater for shipping damage. If
heater is damaged,Contact your customer
service.
CAUTION: DO NOT OPERATE HEATER
WITHOUT SUPPORT FRAME FULLY
ASSEMBLED TO TANK.
NEVER LEAVE HEATER UNATTENDED
WHILE
BURNING
CONNECTED TO A FUEL SOURCE.
ASSEMBLING FRAME AND WHEELS
1. Slide axle through wheel support frame. Install
wheel bushings, flat washers (S) and wheel
on axle. NOTE: When installing wheels, tube valve should face out from support frame.
2. Place flat washers (L) and cotter pins on axle ends and bend cotter pins with long nose pliers to secure.
3. Place wheel cap on flat washers (L) and put wheel cap in flat washers (L) end.
4. Place heater on wheel support frame. Make sure air inlet end (rear) of heater is over wheels. Align the holes
on fuel tank flange. Insert screws through handles (front and rear), fuel tank flange, and wheel support frame
as shown in below and attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
Kerosene Portable Heaters Manual
ASSEMBLY
OR
WHILE
Wheels x2
Axle
M6 Nut x8
M6 Bolt x8
Washer x2
Pin x2
Bushing x2
11
Publicidad
