Eurocave V-ROYALE-L Modo De Empleo página 14

4/ INSTALLING YOUR WINE CABINET
IV. Different installations
Installing two ROYALE cabinets side by side
There is no reason why two ROYALE cabinets cannot be installed side by side.
Installing the cabinet with the back to a wall
If you place your cabinet with its back to the wall, install the stop at the top, at the back of your cabinet. It is located in the accessories bag.
T25 (not supplied)
1
Remove the screws located at the back of your cabinet, at the top,
usinga screwdriver.
Installing the cabinet in a corner
N.B.: If the cabinet is placed in a corner, the door hinge must be fitted so that it does not open more than 90°. If needed, contact your EuroCave
retailer.
T25 (not supplied)
1
Remove the screws fastening the hinge to the door using a T25
screwdriver.
12
3
EN Replace the screws on this new pivot fixing hole.
2
Screw the rear stop using these two same screws.
2
Move forward the hinge attachment by one notch on the right.
110°
90°
5/ LAYOUT – STORAGE
The number of Main du Sommelier supports on each shelf can be adjusted according to the type of bottles stored (Magnums, Champagne, Bordeaux...).
Universal sliding shelf fitted with "Main du Sommelier" support
Ref: ACMSR (Stained black ash front)
Capacity: 9 bottles including 7
Capacity: 9 traditional Bordeaux
traditional Bordeaux bottles + 2
bottles
Wine cabinet layout advice
Your EuroCave wine cabinet is designed to safely hold a maximum number
of bottles. We recommend that you observe the following advice in order
to optimise loading.
•
Ensure that you distribute your bottles as uniformly as possible over the
shelves of your cabinet, in order to distribute the weight over as large an
area as possible.
•
Also ensure that you distribute your bottles uniformly over the height of
I. Changing the position of a sliding shelf
The shelf in the centre of your cabinet is fixed. It is used as a stiffener and cannot be removed. The other shelves in the cabinet can be
moved.
If your sliding shelf is already positioned in your cabinet:
•
Completely unload the sliding shelf.
•
Then remove the sliding shelf by sliding it towards you whilst lifting the front
section.
•
Remove the slide guides from the walls, marking off the right guide and the left
guide.
•
Then proceed to set up the sliding shelf (see diagrams below).
The latch of the soft close device cannot be latched (left and right runners).
It is essential to latch it before positioning the sliding shelf on the runners.
Ensure that the latch is positioned towards the front.
If it is not, pull it forwards to latch it.
a.
Capacity: 5 magnums
magnums
the wine cabinet (avoid loading all the bottles at the top or all the bottles
at the bottom).
•
Observe the loading instructions according to the type of storage
equipment your cabinet has, and never stack bottles on a sliding shelf.
•
Fill the cabinet to more than 75% of its capacity to ensure a uniform
temperature.
When using your wine cabinet, never pull out more than one
sliding shelf at a time.
b.
13
EN