Polisport MOVE JOY CFS Manual De Instrucciones página 5

child in the seat. Then, open the safety buckle (B1) by pressing the safety
buckle button. Seat the child, place the shoulder straps and then close the
safety buckle, adjust the belt length using the strap adjusters, so that your
child is securely restrained. Before starting the journey, always check that the
child is secured and that the belt is snug but not so tight that it hurts the
child. According to the child growth, current height, and weight, you can
adjust the height of the retention system harness (B) on all the strap adjusters
(B2), by pulling up or down the straps until reaching the desired size.
10. After the final adjustment of the retention system harness (B), check that
the shoulder paddings (B4) – Guppy Maxi+; Bilby Maxi – are not too close to
the child's neck to avoid hurting them. The paddings should be positioned
slightly above the shoulders, as shown in the picture.
11. You can also adjust the height of the retention system harness (B) by
choosing between the available holes for retention system adjustment (B5).
HOW TO REMOVE THE SEAT FROM THE BICYCLE
14. Detach the safety-belt (C) to remove the child seat. To remove the seat from the luggage carrier, lift the security ring (G2) and simultaneously unfasten the
hand knob (G1) to open the jaw (G3) wider than the width of the luggage carrier. Push the seat up and backwards.
Make sure you have followed and fulfilled all the instructions given. When
done so, the child bicycle seat is ready for use.
SPECIFIC INSTRUCTIONS FOR USE
• Remove the non-safety-related stickers from the child bicycle seat before
use.
• The rider must be at least 16 years of age.
• Check for any laws and regulations that might be in force in your country,
relating to the carrying of children in seats attached to cycles.
• Carry only children that can sit unaided for a longer period, at least as long
as the intended cycle journey.
• Do not carry a child less than 9 months of age in this child bicycle seat. To
be a passenger, the child must be able to sit up straight with the head held
upright while wearing a bicycle helmet. A doctor should be consulted if the
child's growth is questionable.
• Make sure that the weight and height of the child do not exceed the
maximum capacity of the seat, and check this at regular intervals. Check the
weight of the child before using the child seat. Under no circumstances
should you use the child bicycle seat to transport a child whose weight is
above the permissible limit.
• Make sure to check from time to time that the weight and height of the
child do not exceed the maximum permissible load of the seat.
• Make sure that it is not possible for any part of the child's body or clothing
to come into contact with moving parts of the seat or bicycle and check this
as the child grows.
• You must cover any sharp or pointy objects on the bicycle (e.g frayed
cables) that may be reached by the child, in any situation.
• A wheel protector is recommended to prevent the child from inserting its
feet or hands between the spokes. The use of protection underneath the
saddle or the use of a saddle with internal springs is mandatory. Make certain
that the child is not able to hinder the brakes, thus avoiding accidents. These
adjustments should be revised with child´s growth.
• Cover any exposed rear saddle springs.
• When the child bicycle seat is not in use, fasten the waist buckle of the
WARNINGS
WARNING: Do not attach any additional luggage to
the child seat. If you carry extra luggage, the bicycle' s
carrying capacity must not be exceeded, and we
recommend that it be placed at the front of the bike.
WARNING: Do not modify the seat.
To adjust it, remove the retention system clip from the current hole and place
it on the best hole according to your child height.
12. Model A: To adjust the height of the footrest (E) to fit your child, release
the footrest (E) from the seat (A) by pressing the two fasteners together and
lift the footrest as indicated in the picture (it may be necessary to apply some
pressure to the fasteners). To reattach the footrests, first engage the top pin,
and push the footrest (E) down to lock the clips into the slot's holes.
Model B: Adjust the height of the footrest according to the size of the child.
To do this, raise the lever (E1) and slide it up or down for the required height.
After deciding on the correct height, lower the lever (E1) to lock in place.
13. To guarantee your child's safety, adjust the strap (E2) of the footrest.
Unlock the strap (E2) and adjust it to the child's foot. Lock it again making
sure the strap does not hurt the child.
IT IS MANDATORY TO READ the following chapter on safety
instructions about using your child bicycle seat.
security harness to prevent the straps from dangling and entering in contact
with some turning part of the bicycle as wheels, brakes, etc. as these may be
a hazard to the cyclist.
• Secure the child into child bicycle seat ensuring that all the safety belts and
straps applied firmly but not so tight as to cause discomfort to the child.
• Check the security of fastners frequently.
• You must ensure that you always use the restraint system, and that the child
is secured in the seat.
• Dress the child in proper clothes according to weather conditions.
• Children in child seats need to be more warmly dressed than riders of cycles
and should be protected from rain.
• Remove the seat when transporting the bicycle by car (outside the car). Air
turbulence might damage the seat or loosen its fastenings or other
suspended elements, which could lead to an accident.
• Accompanying persons should carefully consider stability / balance when
placing the child on the bike in the seat.
• Make sure that children wear a suitable helmet that complies with EN
1078:2012+A1:2012 while riding in the seat. Not wearing a helmet
exponentially increases the risk of death, long-term disability, head trauma,
or other injuries. As bicycle seat manufacturers, we care about the safety of
seat passengers, so we strongly recommend that children wear properly
fitted and fastened bicycle helmets.
• The seat and cushion can get hot if under the sun for a long time. Make sure
that they are not too hot before seating the child.
• This child seat is not suitable for use during sporting activities, or in extreme
conditions as per example: enduro, hard mountain biking, big road holes,
jumps and off-road ways.
• When riding for the first time with the seat fitted - to test ride the cycle in a
safe/quiet environment before riding on the highway.
WARNING: The cycle could behave differently with
a child in the seat particularly with regarding to
balance, steering and braking.
WARNING: Never leave the cycle parked with a
child in the seat unattended.
#polisportmove
5