Publicidad
TROUBLESHOOTING GUIDE
Symptom
There is no sound.
Causes
The power cord is not connected properly.
Solutions
* Correct the connection.
An incorrect function selector button is pressed.
*
Press the function selector button to select the correct
input.
There is a bad connection between units.
* Correct the connection.
There is a short circuit in the speaker jack.
The breaker tripped because of a connection to a low-
impedance speaker.
* Disconnect the power cord, correct
the condition,
including speaker connections, and connect the
power cord again.
Sound comes from only
one speaker.
A speaker is disconnected.
« Correct the speaker connection.
The balance is lop-sided.
* Move the BALANCE control to the center position.
There is constant, wave-
like static.
The antenna is not connected properly.
The station is not correctly tuned.
The signal is too weak.
* Check the antenna connection.
* Correct the tuning.
+
Install an outside antenna.
There is noise.
The system picks up outside noise.
* Change the location or direction of the antenna.
+ Turn the system to a different orientation.
* Move the system away from other electrical
appliances, like a TV or fluorescent lights, or move
the appliances.
The sound is distorted.
There's multipath distortion.
+ Change the orientation of the antenna.
*
Replace the antenna with one that has the correct
orientation.
The tape does not run.
Deck 2 is on pause.
+
Press Il and release pause.
The sound is off-balance.
High sounds are too loud.
| There are no high sounds.
The head is dirty.
The DOLBY NR mode is set differently from when the
recording was done.
A non-Dolby NR tape is being played back in that
mode.
* Clean the head.
* Reset DOLBY NR to the same setting as when the
recording was made.
* Turn off DOLBY NR.
The head is dirty.
* Clean the head.
It won't record.
"al
The erase-protection tab on the tape has been broken.
* Cover the erase-protection hole well with tape.
There's an incorrect connection.
* Correct the connection.
The head is dirty.
+ Clean the head properly.
It won't erase.
The erase head is dirty
* Clean the erase head.
69
Publicidad
