Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
To Mount on Wall
Note:
Do not mount the Simplex 125 directly to plasterboard, paneling, brick, or concrete block.
Rather, using appropriate fasteners, secure a board to the wall and then mount the Simplex
125 to the board.
1.
Use the mounting template to mark the points where the
mounting screws for the Simplex 125 are to be installed.
You should mount the clock at a height convenient for
all members of the work force and within 6 ft. of a
power outlet
2.
Leaving 3/16 in. of screw shank exposed, screw two #8
panhead mounting screws (not supplied) into place.
3.
Hang the Simplex 125 from the mounting screws.
4.
Screw a third #8 mounting screw (not supplied) into the
lower left-side hole of the base and tighten to the wall.
If you are replacing the cover at this point, remember to turn
the key back one-quarter turn counterclockwise. The key
must be in this vertical position (or removed) in order for
the cover to snap back into place.
To Connect Power
1.
Remove the cover.
2.
Pass the cable up the channel in the rear of the unit.
3.
Plug the adapter into the circular connector.
4.
Plug the power adapter into the power outlet (note that your
adapter may look different than the one shown at right).
CAUTION! Do not hold the clock when applying power.
The Simplex 125 performs a self-test which in-
cludes cycling the printhead.
You are now ready to set up and program the Simplex 125
(the Programming section starts on page 9).
If you are replacing the cover at this point, remember to turn the
key back one-quarter turn counterclockwise. The key must be
in this vertical position (or removed) in order for the cover to snap back into place.
6
Publicidad
