Cebora SYNSTAR 350 TS Manual De Instrucciones página 52

7�1�2 Start mode
To choose the start mode, select pushbutton C
Start modes are the same for all MIG/MAG processes
The START command for manual applications is available in the wire feeder, either on the torch adapter - it can be
activated using the corresponding pushbutton on the torch - or on the remote control connector.
52
2 stroke mode
Mode appropriate for short welding bursts.
Welding is started by pressing the START pushbutton and ends when the pushbutton is
released.
HSA and CRA functions can be activated in 2 stroke mode�
Automatic mode or 4 stroke mode
Appropriate mode and perform long-term welding. Starting and stopping are controlled by
pressing and releasing the torch START pushbutton.
HSA and CRA functions can be activated in 4 stroke mode�
3 level mode
When the arc strikes, the current is set to the first level. As long as the START pushbutton
is held down, the current remains on the first level. Upon releasing the START pushbutton,
the current passes from first to second level within the slope time; once the second level is
reached, this is maintained. The next time the START pushbutton is pressed, the welding
current will be adjusted to the 3rd level within the set slope time. When the START pushbutton
is released welding stops and the post-flow procedure is run. The HSA and CRA functions
are inhibited in 3-level mode.
HSA mode
By activating HSA mode, the operator can adjust the first current level, the time spent at the
first current level and the first level ramp time at the final welding current.
When the START command is activated, the set values are automatically carried out.
CRA mode
By activating CRA mode, the operator can adjust the final current level (crater current), the
time spent at final current level and the time of the ramp down from the welding current to
the final current. When the START command is deactivated, the set values are automatically
carried out.
Set the desired start mode using the appropriate pushbuttons.
When start mode has been selected, the associated section turns
orange.
START pushbutton pressed
START pushbutton released
3301291-EN 3301291