Cebora SYNSTAR 350 TS Manual De Instrucciones página 56

7�3 Accessories menu
Activate the various accessories available in the power source from the following menu.
If accessories are present in the welding system, they must be connected to the power source before powering
up. Connecting/disconnecting accessories while the power source is switched on leads to system malfunctions
and under extreme circumstances could compromise the integrity of the welding system. CEBORA SpA does not
provide warranty coverage for inappropriate use of the welding system.
To access the Accessories menu, select
7�3�1 Cooling unit
The cooling unit to be used with the SYNSTAR power sources is Item No. 1686 - GRV22.
On power source Item No 379 it is optional, but standard on power sources Item No 382 and 383.
The status bar always shows the cooling unit icon H and unit status is shown in the upper part of the icon: OFF, ON,
AUTO
For correct connection of the cooling unit Item No 1686 to the power source, consult instruction manual code 3301297.
Coolant requirements
The power source is supplied with a minimum quantity of coolant fluid: the customer is responsible for filling the tank
before the system is used.
Use only Cebora coolant (Item No 1514) and read the MSDS carefully to ensure its safe use and correct conservation.
The 5 litre capacity tank inlet is located to the front of the power source. Fill up to max level and top up to make up the
volume of fluid in the pipes after the first system start-up.
NOTE: small fluid leaks will occur during use of the system and particularly when changing the torch or consumables.
Top up weekly to max level.
NOTE: after 6 months, the coolant must be changed completely, regardless of how many hours of work the system
has completed.
56
WARNING
Menu->Accessories
Knob 2 is used to select/activate the operating mode:
OFF
ON
AUTO Cooling unit operates in synchrony with the
welding process
Cooling unit disabled
Cooling unit always on
3301291-EN 3301291