Cebora SYNSTAR 350 TS Manual De Instrucciones página 59

7�4�6 USB Port Management
7�4�7 Use PIN
7�4�8 Change PIN
3301291 3301291-EN
Use knob 2 to select USB Function mode.
When a USB pen drive is inserted into a USB port, the
status bar shows the icon
Remove Select this item to remove the USB pen drive.
Firmware Update Select this item to update the power
source firmware. Create a directory named "Bin" on
the USB pen drive. Upload the .psu file to the "Bin"
directory. Insert the pen drive into the power source
USB port.
Install Options Select this item to install the software
options in the power source. The option release file
loaded on the USB drive must have the extension .txt
and is supplied by Cebora after purchasing the option.
Insert the pen drive into the power source USB port.
Installation can also be carried out using the keypad.
Use the F key to enter the Main menu, press the
key and then press the
Using the alphanumeric keypad enter the unlock code,
then press OK.
Use knob 2 to select Use PIN mode.
A lock code can be used to stop the use of PROCESSES,
MATERIALS and PARAMETERS.
Once Use PIN has been set to ON, press the padlock
key to lock the PROCESSES, MATERIALS and
SETTINGS selections; the padlock key will be closed
and yellow.
To unlock the PROCESSES, MATERIALS and
SETTINGS selections, it will be necessary to enter the
PIN. Default PIN 0000
Use knob 2 to select Change PIN mode.
A lock code can be used to stop the use of PROCESSES,
MATERIALS and PARAMETERS. Default PIN 0000
key.
59