Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Note
When adjusting the height of the saddle post, make sure that the plastic bushing does not
exceed the mark line on the saddle post.
6. Attach the footrest (96) onto the main frame (1). Tighten the assembly with the spanner
provided. Fig. 14
Step 4: Left and right handrail arms and console installation
1. Insert the right handrail arm (4) into the tube of the right handrail (5) and fix it with two
M8x40 carriage bolts (29), two Ф20xФ8x1,5 curve washers (30) and two M8 cap nuts
(31).
2. Repeat the same procedure to assemble the left handrail arm (3).
3. Connect the sensor wire (19) to the extension sensor wire (13).
4. Remove two hex bolts M8x16 (15) and two curve washers Ф16xФ8x1.5 (16) from the main
frame (1).
5. Attach the console post (2) onto the main frame (1) with the two hex bolts M8x16 and
two curve washers Ф16xФ8x1.5 (16) previously removed. Tighten the assembly with the
Allen key provided.
6. Remove two M5x10 cross pan head screws (12) from the console (11).
7. Then attach the console (11) onto the upper end of the console post (2) with the two
M5x10 cross pan head screws (12) previously removed. Tighten the screws using the
spanner with Philips screwdriver provided.
8. Connect the extension sensor wire (13) to the wire of the console (11). Fig. 15
4. OPERATION
Keys
MODE
Press to select a function. If held down for a few seconds, the MODE key will display the value
0.
SET
Press to set the time, distance, pulse and calorie values when not in SCAN mode.
RESET
-
Press to reset the time, distance, and calorie values. There is no factory data saved, so
the console will display 0.
-
If the RESET button is held down for a few seconds, except for the ODO function, the
counter will be reset and will show the value 0.
62
DRUMFIT CROSSFIT 3000 EOLO
Publicidad
