Prebena PKT-8-RHC40 Manual Del Usuario página 149

Feature Possible cause
The insertion
depth is set
too low for
the material.
No nails are The magazine or
driven in shot channel are
when the dirty.
fastener
driving tool
is triggered.
Wrong nails are
loaded in the
magazine.
Operating
pressure is too
low.
The driving in
process is not
performed
completely.
The red LED The battery
in the control charge is too low.
panel is lit The tool switches
continuously off after
and the tool 10 seconds.
beeps at a 1-
second
interval.
The red LED The operating
in the control temperature is too
panel is lit at high. The tool
a 0.5-second switches off after
interval. 10 seconds.
Eliminating malfunctions
Remedy
▶ Increase the insertion depth
(see page 47).
▶ Turn off the tool.
▶ Remove the magazine.
▶ Remove foreign objects from
the shot channel and magazine.
▶ Emptying the magazine.
▶ Fill the magazine with nails
that are permitted for the magazine
(see page 27).
▶ Add more compressed air from
the cartridge (see page 32).
▶ Contact Customer Service
(see page 74).
▶ Charge the battery.
▶ Allow the tool to cool off for at least
15–30 minutes.
▶ Check whether the exhaust air
opening and air intake opening
are free.
▶ Clean them if necessary.
67