Publicidad
Idiomas disponibles
Idiomas disponibles
1.
. Displayed when the RPM IG mode is selected. In this mode, revolutions per minute on 1 to
12 cylinder engines can be measured using the test leads on the primary side of the ignition coil.
2.
. Displayed when the RPM IP mode is selected. In this mode, revolutions per minute on 2- or
4-stroke engines can be measured using the Inductive Pickup on a spark plug wire.
3.
. Displayed when dwell mode is selected.
4.
.
Displayed when duty cycle mode is selected.
18
5.
. Displayed when a certain number of cylinders is selected in the RPM IG or Dwell mode. Press the
"RANGE" button to toggle between 1, 2, 3, 4, 5, 6, 8, 10, 12 cylinder engines.
6.
. Displayed when 4 strokes are selected in the RPM IP mode. Press the "RANGE" button to toggle
between 2-stroke and 4-stroke engines.
7.
. Displayed when 2 strokes are selected in the RPM IP mode. Press the "RANGE" button to toggle
between 2-stroke and 4-stroke engines.
8.
. Indicates that the value being displayed is the average of all readings taken since the Recording mode
was entered.
9.
. Displayed when diode test is selected.
10.
. Displayed when Relative mode is active.
11.
.
Displayed when Recording mode is active.
12.
.
Displayed when continuity test is selected.
13.
.
Displayed when the Hold mode is active.
14.
. Displayed when the battery is low.
TO AVOID FALSE READINGS, WHICH COULD LEAD TO POSSIBLE ELECTRIC SHOCK OR PERSONAL
INJURY, REPLACE THE BATTERY AS SOON AS THIS LOW BATTERY INDICATOR APPEARS.
. Indicates that the value being displayed is the maximum reading taken since the Recording mode
15.
was entered.
16.
. Displayed when autorange mode is active.
17.
. Indicates that the value being displayed is the minimum reading taken since the Recording mode was
entered.
18.
. Displayed when DC measurement function is selected.
19.
. Displayed when AC measurement function is selected.
20.
. Indicates negative readings. In Relative mode, this sign indicates that the present input is less than
the stored reference.
21.
. Indicates that the automatic power-off feature has been enabled.
22.
. Indicates that USB communication function has been turned on.
23.
. Displayed when a – or + trigger slope is selected while the meter is in the RPM IP or RPM IG (Duty
Cycle, Pulse Width, Hz or Dwell) mode. The meter defaults to a – (negative) trigger slope. Press the "±
TRIG" button for 1 second to toggle between negative (-) and positive (+) trigger slope. Also displayed
when the bargraph indicates trigger level.
800.MACTOOLS
All manuals and user guides at all-guides.com
WARNING
15
Publicidad
