RECEPTACLES
120/240 Volt AC, 30 Amp,
Locking
Receptacle
Use a N EMA LI4-30 plug with this receptacle. Connect a
4-wire cord set rated for 250 Volt AC loads at 30 Amps (or
greater) (Figure 8).You can use the same 4-wire cord if you
)lan to run a 120Volt load.
4-WireCord
Set
f
(Neutral)
Y (Hot)
|
X (Hot)
NEMA L 14-30
/--_
Ground
(Green)
This receptacle powers 120/240Volt AC, 60 Hz, single
phase loads requiring up to 4,500 watts of power (4.5 kW)
at 30 Amps for 120Volts or 240Volts.The outlet is
protected by a push-to-reset circuit breaker.
_
CAUTION!
Although
this outlet states it has a
120/240 Volt 30 Amp rating (up to 7,200 watts), the
generator
is only rated for 4,500 watts. Powering
loads that exceed the wattage/amperage
capacity of
the generator
can damage it or cause serious
injuries.
120 Volt AC, 20 Amp, GFCI
Duplex
Receptacles
Each duplex receptacle (Figure 9) is protected against
overload by a push-to-reset circuit breaker.
•11 I
•11 I
Use each receptacle to operate 120Volt AC, single-phase,
60 Hz electrical loadsrequiring up to 2,400 watts (2.4 kW)
at 20Amps of current. Use cord sets that are rated for
125Volt AC loads at 20 Amps (or greater).
Ground
Fault Protection
This unit is equipped with a Ground Fault Circuit
Interrupter (GFCI).This device meets applicable federal,
state and localcodes.
The GFCI protects against electrical shock that may be
caused if your body becomes a path which electricity
travels to reach ground.This could happen if you touch a
"Live" appliance or wire, or are touching plumbing or other
materials that connect to the ground.
When protected by a GFCI, one may still feel a shock, but
the GFCI should cut current off quickly enough so that a
person in normal health should not suffer any serious
electrical injury.
_
CAUTION!The
GFCI will not protect you
against the following situations: (I) Line-to-line
shocks; (2) Current overloads or line-to-lineshort
circuits.The fuse or circuit breaker at the
distribution panel must provide such protection.
/
9