Sears Kenmore 24 Manual Del Usuario página 12

[_ Connect the Tubing to the
Refrigerator.
Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
We recommend installing a water filter if your water
supply has sand oz' particles that could clog the screen
of the refrigerator's water valve, Install it in the water
line near the refiige, ator
a. Remove the plastic flexible cap f_om the water valve.
b_ Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown.
co Insert the end of the copper tubing into the water
valve connection as far as possible. While holding
the tubing, tighten the fitting.
d. Fasten the copper tubing into the clamp provided
to hold it in position. You may need to pry open
the clamp.
One of the illustrations below will look like the
connection on your refiigerator_
[[_] Turn the Water On at the Shutoff
Valve.
Tighten any connections that lea.k_
[7] Plug In the Refrigerator.
Airange the coil of copper tubing so that it does not
vibrate against the back of the refrigerator or against
the wall.
Push the refrigelator back to the wall.
[-8-]Start the Ilcemaker
Set the icemalier feeler arm to the ON (down)
position. The icemaker will not begin to opezate until
it reaches its operating temperature of 15°E (-9°C) or
below. It will then begin operation automatically if the
icemaker feeler arm is in the ON (down) position.
Note:
The icemal;er may double-cycle when it first
staIts, causing some water spillage from the icemaker
into the ice bucket, This is normal and should not
happen again.
Tubing
I/4"
Compression -_.,.
Nut
Ferrule
Copper
Tubing
Refrigerator
Connection
12