Sears Kenmore 24 Manual Del Usuario página 6

Re¢ [ge ator [Instal[[at[on
Door Aaignment
After leveling, make sure that
the door's are even at the top_
Hake sure doors
are even at the top,
-q
!
i
L
Uneven Doors
To make the doors
even, adjust the fresh
food door. Insert a
3116" Allen wrench
into the bottom of
the hinge pin, Turn
the door' adjusting
screw to the right to
raise the door, to the left to lower it. (A nylon plug,
imbedded in the threads of the pin, prevents the pin
from turning unless a wrench is used.) After' one or
two turns of the wrench, open and close the f}esh fdod
door and check the alignment at the top of the doors.
Tr rn
Kits and DecoFator
For BuHt4n models
Some models are equipped with trim kits that allow you
to install door panels° You can older pre-cut black or
white decorator panels from your Sears Service Center, or
you can add wood panels to match your ldtchen cabinets.
Paneas Less Than 1/4" (6 mm) Thick
When installing wood panels less than t/4" (6 ram)
thick, you need to create a filler panel, such as 118"
cardboard, that wil! fit between the face of the door'
and the wood panel. If you are installing the pre-cut
decorator panels, pre-cut filler-panels are included in
the ldto The combined thickness of the decorator or
wood panel and the filler panel shotdd be I/4" (6 mm)_
Care of Pre-Cut Panels
Clean these panels using an anti-static cleaner' or a
mild detergent and water. (Look for anti-static cleaner
in electronic or computer departments.) Rinse
thoroughly and blot dry with a clean, damp cloth or'
chamois. Do not use paper towels to wash or di 7 the
panels. Do not use cleaners that contain solvents, such
as ammonia, because they can damage the panels,.
Shallow sczatches and abrasions can be corrected with
a good grade of hard automobile paste wax. Do not
use a cleaner/wax combination. The wax will fil! in any
minor' surface scratches and wilt help to maintain the
luster' of the panels,. Apply the wax sparingly and buff
lightly with a clean, soft cloth using a circular motion..
Pane JnstaJSation
3/4" (19 ram) or Raised Panel
A raised panel design screwed or"glued to a 114"
(6 mm) thick bacldng, or a 3/4" (19 ram) routed
boar'd can be used. The raised portion of the panel
must be fi_bricated to permit clearances of at least 2"
(51 mm) fiom the handle side for fingertip clearance.
Weight limitations for custom panels:
Fresh Food: 35 lb. (16 kg) max.
Freezer Door: 25 Ib._(11 kg) max.
114" (6 ram)
Thick Backing
J
2" (5t ram)
Clearance
Handle Side
Appearance
Panel
3/4" (19 ram)
Retrigerator
Door