Publicidad
Idiomas disponibles
Idiomas disponibles
Specified System Components:
UNIDRIVE-Working Device
÷
with appropriate rope length
Guided type fall arrester including a flexible anchor line EN 353-2 (for example Mittelmann 12mm safety
÷
rope in the appropriate length and guided-type fall arrester AH3 or AH4) or retractable type fall arrester
EN360
Full body harness in accordance with EN 361
÷
(for example, MKA20 E Klick Fit Eyelet RST 190 with optional seat cushion SP2 Adapter Profi)
Connecting elements in accordance with EN 362
÷
Powerlink (cordless screwdriver fixing on the UNIDRIVE)
÷
For use as a working device, the above listed products are so combined for a planned work assign-
ment that secure, comfortable working is enabled.
The MKA20 E Klick Fit is recommended as a full body harness. With this combination the body of the
user is so held and supported that comfortable working is made possible. The SP2 seat cushion with
footrest provides relief to the body in the full body harness.
Application Travelling:
The UNIDRIVE working device is fastened to the front eyelet of the full body harness and to the seat
cushion eyelet. Thereby is ensured that the user is attached in a sitting position.
The free fastener (top) of the UNIDRIVE is attached to a suitable anchor point.
As an additional second safeguard for the user, the safety rope is attached to a second anchor point
and the fasteners of the guided-type fall arrester are attached to the rear eyelet of the body harness.
With this protective arresting device, the user is permanently protected against falling. In the event of a
fall or a too high a descent speed, the guided-type fall arrester is arrested and brings the user to a
safe stop.
Information
:
Initial instruction and training by the manufacturer, or an instructor trained by him, before commission-
ing is required by law as only a trained user is safely in control of the UNIDRIVE as a working device
equipment in all work situations.
Original Operating Instructions UNIDRIVE
Page 33
Publicidad
