Bobbin Winding - Janome Hello Kitty hk15822 Manual De Instrucciones

q
2
x
z
v
c

Bobbin Winding

• Removing bobbin case
Remove the extension table from the
machine by pulling it to the left. Open the
shuttle cover q by pushing down the
embossed part on the cover.
Raise the needle to its highest position by
rotating the handwheel toward you.
q Shuttle cover
w Bobbin case
To remove the bobbin case w from the
shuttle, pull open the latch of the bobbin
case. Pull the bobbin case straight out of
the shuttle.
• Bobbin winding
z Draw thread from the spool.
Guide the thread around the thread guide.
x Thread through the hole in the bobbin
from the inside to the outside.
Put the bobbin on the bobbin winder
spindle.
c Push the bobbin to the right.
v With the free end of the thread held in
your hand, depress the foot control. Stop
the machine when the bobbin has wound
a few layers, and cut the thread close to
the hole in the bobbin.
14