Janome Hello Kitty hk15822 Manual De Instrucciones página 44

b
n m
,
.
! 4
! 1
! 2
! 3
40
b Depress the foot control to sew a
buttonhole.
The machine will sew the front bartack,
left row, back bartack and right row
automatically. Stop the machine at the
ending point.
!1 Ending point
n Raise the presser foot and cut the both
needle and bobbin threads leaving
10 cm (4˝) thread ends.
Draw the needle thread to wrong side of
the fabric by pulling the bobbin thread.
Then, knot the threads.
m Remove the fabric and place a pin just
before the bartack at each end to
prevent cutting bartacks. Cut the
opening with the seam ripper.
!2 Pin
!3 Seam ripper
• To repeat buttonhole sewing
, To repeat buttonhole sewing, turn the
stitch selector to
again, as shown.
Now, simply step on the foot control to
sew an identical buttonhole.
. When the buttonhole sewing is finished,
push the buttonhole lever upward as far
as it will go.
! 4 Buttonhole lever
• Adjusting buttonhole stitch density
Turn the stitch length dial to the right for a
coarser density.
Turn the stitch length dial to the left for a
tighter density.
, then back to