Publicidad
Idiomas disponibles
Idiomas disponibles
ALLEN KEY STORAGE
There is a storage location on the saw to store
the Allen key.
When not in use, store the Allen key as shown
in the Fig. 3 to prevent it from being lost.
TO REMOVE OR INSTALL THE BLADE
(FIG. 4a – 4e)
WARNING
pack before making any adjustments or
assembling parts.
WARNING
blade diameter in accordance with the
markings on the saw and are marked with a
speed equal or higher than the speed
marked on the tool.
WARNING
(305mm) and 1" (25.4mm) arbor. The blade's
maximum plate thickness is 0.100" (2.54mm).
WARNING
4000/min (RPM) or greater.
CAUTION
blades. Blade tips are sharp and can cause
personal injury.
To remove the blade:
a. Remove the battery pack.
b. Position the head assembly in the UP
position and at 0° bevel. If in the DOWN
position, press down slightly on the saw head
assembly and pull out the head assembly
lock pin (Fig. 4a).
c. Tighten the slide-rail lock knob so that the
head assembly is secured in place (Fig. 4a).
d. Push the SpindleStop™ spindle lock down
(Fig. 4b). Rotate the blade slowly until it fully
seats into its locked position.
(FIG. 3)
Always turn the tool off
and remove the battery
Only use wood-cutting
blades that have a saw-
To avoid injury, only use a
blade with diameter of 12"
To reduce risk of injury,
use saw blade rated
Always wear gloves when
changing or handling
Fig. 3
Fig. 4a
Head Assembly
Lock pin
Slide-rail
Lock Knob
Fig. 4b
Spindle Lock
Fig. 4c
-16-
Spindle Locked
Position
Tighten
Loosen
Publicidad
