Publicidad
Idiomas disponibles
Idiomas disponibles
Your risk from these exposures varies,
depending upon how often you do this type
of work. To reduce your exposure to these
chemicals:
Work in a well-ventilated area.
–
Work with approved safety equipment, such
–
as dust masks that are specially designed to
filter out microscopic particles.
1. This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
NOTICE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
Electric brake
Your saw is equipped with an automatic electric
brake which is designed to stop the blade
from spinning in about five (5) seconds after
you release the trigger switch. It is useful when
making certain cuts in wood where a coasting
blade would result in a wide, imprecise cut.
WARNING
other causes, the motor will gradually slow
down and the braking action is initiated
ONLY by the release of the trigger switch.
The electric blade brake of your miter saw
has been designed for highest degree of
reliability, but unexpected circumstances
such as contamination on the commutator
ELECTRICAL REQUIREMENTS
When electrical power is
lost due to blown fuse or
Avoid prolonged contact with dust from
–
power sanding, sawing, grinding, drilling, and
other construction activities. Wear protective
clothing and wash exposed areas with soap
and water. Allowing dust to get into your
mouth or eyes or to lie on the skin may
promote absorption of harmful chemicals.
FCC CAUTION
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the
•
equipment and receiver.
Connect the equipment into an outlet on a
•
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
•
technician for help.
and brushes, failure of motor's components
or overheating can cause the brake not to
activate. If this condition occurs, turn the saw
"ON" and "OFF" four to five times without
contacting the workpiece. If the tool operates
but the brake does not consistently stop
the blade in about five seconds, DO NOT
use saw and have it serviced immediately.
WARNING
safety feature. Remember to let the saw
blade come to a complete stop before
raising the blade from the workpiece. As
always, the guard system is your best
protection against unintentional contact with
a spinning saw blade. NEVER wedge open or
defeat the closing action of the lower guard.
-7-
The brake action of this
saw is not intended as a
Publicidad
